Walls ready

Ready for the wall to go on.

Glue and some weight add a few brads every now and then.

Using a 1/4" flush trim router bit to cut plywood to shape of finish wall.

Coated the edges with the bed liner so there will not ever be any water damage.

Pretty sure I should have some cabinets in first but I haven't finished the design yet,,,,,and I have an A-frame hoist to hold them in place.

Wheel wells

After a previous tire blow out and axle spring failure my wheel wells were not in very good shape so I thought I would have a local sheet metal shop make me some new ones.

WELL......at east that is what I thought....I got an estimate of OVER $400 for the 2.....NOPE.

I'll do it myself

Axle

I wanted this little Scotty to pull and ride well.

So......NEW Flexiride Torsion Axle

I went with a 3500# derated to 3000#

Axle

Floor started

Time for the floor to go back together.

I went with 3/4" Huber Blue Plus

Same product as Advantech but not quite as expensive.

Wanted to get a good coating on the floor.

So I went with truck bed liner.

All types can be used but since I am frugal....Harbor Freight here I come.

Iron Armor Truck Bed coating